Day94 Put in the pilot house top frames
Great!! After playing around with the cambers, and making them all match the master, things worked out much better!  
The ends of the frames did actually have a difference in them from fore to aft. We just carefully marked out the sides with a flatbar, then rose each side equally until the center was level with the preceding piece.
This worked out quite well here, as the change in width isn't much, but for the cabin top things will have to be done differently as neither the cabin top sides or the center are to be level!
We have devised a method of doing this, I hope it works!
Day 94 was a Saturday, had to go to work, so only 3 hours, but it was enough!

Day 94:
3 hours - Rebent cambers for pilot house, and welded 'em in!

To DAY 93
Tough electronic repair job?

Call Sandy's CB (780) 986-7433
for a solution!

To DAY 95+